<ol id="jzd93"><sub id="jzd93"></sub></ol>

<cite id="jzd93"><address id="jzd93"><ins id="jzd93"></ins></address></cite>

<meter id="jzd93"><address id="jzd93"><b id="jzd93"></b></address></meter><del id="jzd93"></del>
    <sub id="jzd93"><progress id="jzd93"></progress></sub>

    <sub id="jzd93"><menuitem id="jzd93"></menuitem></sub>

        <mark id="jzd93"></mark>

        <delect id="jzd93"></delect>
        <dfn id="jzd93"></dfn>

          image left

          Here are some examples of cuts in both clear plastic and polyimide using a variety of laser types.?

          In the following figures, "A" shows clear plastic, while "B" shows polyimide.

          Figure 1A Figure 1B Figure 1 shows the 1.5 W, 355 nm laser results.? Both cuts are relatively clean with a small heat affected zone (HAZ). It took about one minute to make a complete part.
          Figure 2A Figure 2B Figure 2 shows the 3.0 W, 355 nm laser results.? A slightly higher HAZ, but still decent quality.? These parts took about 18 seconds to process at double the power of the previous.
          Figure 3A Figure 3B Figure 3 shows the 1.5 W, 266 nm laser results.? With one of the best cut qualities, this one still took the least time of the tested UV lasers, 12 seconds.
          Figure 4A Figure 4B Figure 4 shows the broadband RF CO? laser.? It took only about 400 ms to make the cut, but it's pretty poor quality?with a large HAZ.
          Figure 5A Figure 5B Figure 5 shows the 9 μm RF CO? laser.? Still can't compete with the UV lasers.? This also took about 400 ms.
          Figure 6A Figure 6B Figure 6 shows the results of a line-narrowed CO?-T laser.? Good cut quality, nice thin line.
          Figure 7A Figure 7B Figure 7 shows Q-switched CO? results.? The process speed was about 700 ms and produced results comparable to the UV lasers.
          Figure 8A Figure 8B Figure 8 shows cuts made with a 248 nm KrF Excimer laser.? The process took hours, not seconds, but not the exceptional edge quality.
          Figure 9A Figure 9B Figure 9 shows cuts made with a 355 nm, 12 ps laser.
          Figure 10A Figure 10B Figure 10 shows cuts made with a 532 nm, 12 ps laser.
          Figure 11A Figure 11B Figure 11 shows cuts made with a 1064 nm, 12 ps laser.

           

          能提现的游戏